vinyl car wrap colors Wrapping an antenna with one sheet of vinyl wrap film

vinyl car wrap colors

Vinyl wrap film can be used to wrap antennas in many ways. vinyl car wrap colors Here's a simple way to wrap an antenna with vinyl wrap film: use relief cuts to wrap it in one piece. Clean the antenna well before applying. vinyl car wrap colors Once the antenna is dry, wrap masking tape around its bottom (not necessarily at the base, but just a little). Masking tape is a great way to prevent vinyl wrap film sticking to the roof. vinyl car wrap colors This is especially important if you use an aggressive material. It can also make it easier to pick up vinyl wrap film later. Once the masking tape has dried, apply the vinyl wrap film on the antenna. Apply the vinyl wrap film to the roof by tacking it lightly. Then, pull the film towards the back of the antenna. Next, take one side of your antenna and pull in a triangle towards the back. This will distribute the material and even the tension on vinyl wrap film. When the film is fully set, secure it on this side. You can pick the material up bit by bit using one hand. Then, use the soft end of your squeegee with the other to remove the film from the antenna. vinyl car wrap colors This will ensure that the film doesn't wrinkle in the middle. www.vinylcarwrapshop.com You might find small wrinkles at the bottom. Use the hard end of the squeegee for these wrinkles and then tuck the material in the edge. Once you have completed the antenna's one side, you can now make your relief cuts on the backside. You can now wrap the film around this area and create a hinge.

Once it is done, sharpen your knife and begin to cut along the hinge (from the bottom up). vinyl car wrap colors Once your blade reaches its top, you can cut around the antenna's top without removing the other side. The antenna can be exposed by lifting the film from the backside. Wrap the extra three millimeters of material around the antenna's backside using your finger. vinyl car wrap colors You can cut along the bottom contour of the antenna. Remove excess material and use your squeegee for tucking the film under. The same process can be used to deal with the antenna's other side. After wrapping the antenna properly, you can remove a little bit of the base. You have a piece that hangs in the air. This can be used to cover the backside the antenna. vinyl car wrap colors You can use your squeegee for a smooth finish. As you reach the corner, pay more attention. Once you are done, vinyl car wrap colors place your overlap on the contour to blend it all in. Finally, remove any excess material. You will now have a perfectly wrapped antenna. Find out more about wrap tips at teckwrap.com Antenna Relief cut